Browsing by Author "Bayer, Ozgur"

Now showing 1 - 2 of 2

Citation - WoS: 15
Citation - Scopus: 15
Developing and Implementation of an Optimization Technique for Solar Chimney Power Plant With Machine Learning
(Asme, 2021) Kocak, Eyup; Bayer, Ozgur; Beldek, Ulas; Yapic, Ekin Ozgirgin; Ayli, Ece; Ulucak, Oguzhan; 59950; 31329; 265836; 06.06. Makine Mühendisliği; 06.08. Mekatronik Mühendisliği; 06. Mühendislik Fakültesi; 01. Çankaya Üniversitesi
Green energy has seen a huge surge of interest recently due to various environmental and financial reasons. To extract the most out of a renewable system and to go greener, new approaches are evolving. In this paper, the capability of Artificial Neural Network and Adaptive Neuro-Fuzzy Inference System in geometrical optimization of a solar chimney power plant (SCPP) to enhance generated power is investigated to reduce the time cost and errors when optimization is performed with numerical or experimental methods. It is seen that both properly constructed artificial neural networks (ANN) and adaptive-network-based fuzzy inference system (ANFIS) optimized geometries give higher performance than the numerical results. Also, to validate the accuracy of the ANN and ANFIS predictions, the obtained results are compared with the numerical results. Both soft computing methods over predict the power output values with MRE values of 12.36% and 7.25% for ANN and ANFIS, respectively. It is seen that by utilizing ANN and ANFIS algorithms, more power can be extracted from the SCPP system compared to conventional computational fluid dynamics (CFD) optimized geometry with trying a lot more geometries in a notably less time when it is compared with the numerical technique. It is worth mentioning that the optimization method that is developed can be implemented to all engineering problems that need geometric optimization to maximize or minimize the objective function.
Citation - WoS: 2
Citation - Scopus: 4
Optimization of Vortex Promoter Parameters To Enhance Heat Transfer Rate in Electronic Equipment
(Asme, 2020) Ayli, Ece; Bayer, Ozgur; 265836; 06.06. Makine Mühendisliği; 06. Mühendislik Fakültesi; 01. Çankaya Üniversitesi
In this paper, optimization of the location and the geometry of a vortex promoter located above in a finned surface in a channel with eight heat sources is investigated for a Reynolds number of 12,500 < Re < 27,700. Heat transfer rates and the corresponding Nusselt number distributions are studied both experimentally and numerically using different vortex promoter geometries (square, circular, and triangular) in different locations to illustrate the effect of vortex promoter on the fluid flow. Optimization study considered a range of following parameters: blockage ratio of 0.30<(y/C) < 0.45 and interpromoter distance ratio of 0.2277 <(x/L) < 0.3416. Results show that fins over which rectangular and circular promoters are integrated perform better in enhancing the heat transfer. According to the numerical and experimental results, higher blockage ratios cause significantly higher heat transfer coefficients. According to the observations, as the interpromoter distances increase, shedding gains strength, and more turbulence is created. All vortex promoters enhance heat transfer resulting in lower temperature values on the finned surface for different (y/C) and (x/L) values and Reynolds numbers. The use of promoters enhances the heat transfer, and the decrease in the maximum temperature values is recorded on the finned surface changing between 15% and 27%. The biggest decrease in maximum surface temperature value is 500 K-364 K and observed in circular promoter case with (y/C) = 0.43, (x/L) = 0.3416, and Reynolds numbers of 22,200.