Browsing by Author "Ozturk, Ali"

Now showing 1 - 4 of 4

Citation - WoS: 1
Citation - Scopus: 2
A fixed point theorem for a system of Pachpatte operator equations
(Springer Basel Ag, 2021) Karapinar, Erdal; Karapınar, Erdal; Ozturk, Ali; Rakocevic, Vladimir; 19184
In this paper, we investigate sufficient conditions for the existence of solutions to the system {Tx=x, alpha(i)(x)=0(E), i = 1,2, ... r, where 0(E) is the zero vector of E, and alpha(i) : E -> E i = 1, 2, ... , r are mappings, T is a mapping satisfying the Pachpatte-contraction.
Citation - WoS: 0
Citation - Scopus: 2
Analytical Solution of Thermal Stresses In A Functionally Graded Solid Cylinder Within Parabolic Continuous Grading
(Trans Tech Publications Ltd, 2013) Ozturk, Ali; Gülgeç, Müfit; Gulgec, Mufit; 4168
This paper presents analytical solutions of the thermal stresses in a functionally graded solid cylinder with fixed ends in elastic region. These thermal stresses are due to the uniform heat generation inside the cylinder. Material properties of the functionally graded (FG) cylinder vary radially according to a parabolic form. The material properties are assumed to be independent of the temperature which are yield strength, elasticity modulus, thermal conduction coefficient, thermal expansion coefficient and Poisson's ratio. The solutions for the thermal stresses are valid for both homogeneous and functionally graded materials.
Citation - WoS: 48
Citation - Scopus: 55
Elastic-plastic stress analysis in a long functionally graded solid cylinder with fixed ends subjected to uniform heat generation
(Pergamon-elsevier Science Ltd, 2011) Ozturk, Ali; Gülgeç, Müfit; Gulgec, Mufit; 4168
Elastic-plastic deformation of a solid cylinder with fixed ends, made of functionally graded material (FGM) with uniform internal heat generation is investigated, based on Tresca's yield criterion and its associated flow rule, considering four of the material properties to vary radially according to a parabolic form. These four material properties are yield strength, modulus of elasticity, coefficients of thermal conduction and thermal expansion, assumed to be independent of temperature as Poisson's ratio which is taken as constant. The materials which compose the functionally graded cylinder are supposed to be elastic-perfectly plastic materials. Expressions for the distributions of stress, strain and radial displacement are found analytically in terms of unknown interface radii. After determining these radii numerically by means of Mathematica 5.2, the distributions are plotted versus dimensionless radius, increasing heat generation, to compare the FGM cylinder with the homogeneous one. The numerical values used in this work for material parameters are arbitrarily chosen to point out the effect of the non-homogeneity on the stress distribution. The results obtained show that the stress distribution, as well as the development of plastic region radii, is influenced substantially by the material non-homogeneity. (C) 2011 Elsevier Ltd. All rights reserved.
Citation - WoS: 4
Citation - Scopus: 4
Influence of the material properties on the elastic-plastic deformation in a heat generating composite solid cylinder
(Gazi Univ, Fac Engineering Architecture, 2013) Ozturk, Ali; Gülgeç, Müfit; Gulgec, Mufit; 30494; 4168
Based on Tresca's yield criterion and its associated flow rule, the elastic-plastic deformation of a centrally heated composite cylinder with fixed ends is investigated by considering the influence of geometric parameters as well as material properties such as yield strength, modulus of elasticity, Poisson's ratio, coefficient of thermal conduction and thermal expansion. In the study, stress, strain and displacement distributions in the composite cylinder made of elastic-perfectly plastic material are derived. Stress distribution and evolution of plastic regions in the composite are presented for different levels of heat generation in the core.